Motorola RFS Series System Reference Manual page 365

2. Click the Configuration
The MU Intrusion Detection tab consists of the following two fields:
• Collection Settings
• Violation Parameters
3. Within the Collection Settings
to scan for MU violations. The available range is from 5 - 300 seconds.
4. Refer to the Violation Parameters
Violation Type Displays the name of the violation for which threshold values are set in the MU,
radio and switch columns.
Trigger Against Displays what conditions will trigger the violation parameter against Authorized
(Auth, Unauth, APs, Unauthorized APs and Ignored APs. If a violation is triggered by an AP type it
Ignore) will display with a green check box. If it is not triggered on an AP type it will
display with a red X.
Threshold Values for Set the MU threshold value for each violation type. If exceeded, the MU will be
Mobile Unit filtered and displayed within the Filtered MUs screen.
Threshold Values for Set the radio threshold value for each violation type. If exceeded, the radio will be
Radio filtered and displayed within the Filtered Radios screen.
Time to Filter Set the Time to Filter interval (in seconds) the switch uses to filter out MUs defined
as committing a violation. Refer to
the contents of the MUs that have been filtered thus far.
tab.
field, set the Detection Window
field to define threshold values that trigger an alarm:
Viewing Filtered MUs on page 6-12
Switch Security
interval (in seconds) the switch uses
to review
6-11