Motorola RFS Series System Reference Manual page 235

4. Click the Edit button to display a screen to change the radio adoption default values for the currently
selected radio type (802.11b, 802.11bg and 802.11bgn or 802.11a and 802.11an).
The Properties field displays the
and cannot be modified. The
802.11a and 802.11an). This value is read only and cannot be modified.
5. To use this radio as a detector to identify rogue APs on your network, check the box titled
AP as Detector AP. Setting this radio as a detector will dedicate this radio to detecting rogue APs on
the network. Dedicated detectors do not connect to by clients.
6. Select the Single-channel scan for Unapproved APs
devices using its only current channel of operation.
7. Select the Enable Enhanced Beacon Table
association information.
8. Select the Enable Enhanced Probe Table
the switch.
9. Within the Radio Settings
The setting will affect the selection channel and power levels. Default is Indoors.
10.Select a channel for communications between the Access Port and MUs in the
The selection of a channel determines the available power levels. The range of legally approved
communication channels varies depending on the installation location and country. The selected channel
can be a specific channel, "Random," or "ACS." Random assigns each radio a random channel. ACS
(Automatic Channel Selection) allows the switch to systematically assign channels. Default is Random.
Model family for the selected Access Port. The
Radio Type displays the radio type (802.11b, 802.11bg and 802.11bgn or
checkbox to allow the AP to receive beacons and
checkbox to allow an AP to forward MU probe requests to
field, configure the Placement
Model
checkbox to enable the switch to detect rogue
of the radio as either Indoors
Desired Channel
4-133
Network Setup
is read only
Dedicate this
or Outdoors.
field.