Motorola RFS Series System Reference Manual page 95

Protocol Use the
resident switch
the default setting.
Password Enter the password required to access the server.
SWITCH NOTE: In addition to the
update using USB or Compact Flash. On the RFS6000, users can also auto-update using
USB.
3. Refer to the Redundancy Configuration
cluster file updates.
Enable Select the
(updated) file is detected (upon the boot of the switch) at the specified IP address.
IP Address Define the
is detected when the switch is booted, it will be uploaded to the switch and used
upon the next boot of the switch.
User ID Enter the
File Name (With Provide the complete and accurate path to the location of the cluster files on the
Path) server. This path must be accurate to ensure that the most recent file is retrieved.
Protocol Use the
resident switch
the default setting.
Password Enter the password required to access the server.
4. Refer to the Firmware
enabled, the located (updated) switch firmware is used with the switch the next time the switch boots.
Enable Select the
(updated) version is detected (upon the boot of the switch) at the specified IP
address.
IP Address Define the
version is detected when the switch is booted, it will be uploaded to the switch
and used upon the next boot of the switch.
User ID Enter the
File Name (With Provide the complete and accurate path to the location of the firmware files on the
Path) server. This path must be accurate to ensure that the file is retrieved.
Protocol Use the
resident switch
the default setting.
Password Enter the password required to access the server.
Version Provide the target firmware version to ensure that the switch is upgrading to the
intended baseline.
Protocol drop-down menu to specify the
FLASH medium used for the file update from the server. FLASH is
Protocols
field to enable and define the configuration for automatic
Enable checkbox to allow an automatic cluster file update when a new
IP address of the server where the cluster files reside. If a new version
User ID required to access the FTP or TFTP server.
Protocol drop-down menu to specify the
FLASH medium used for the file update from the server. FLASH is
field to enable and define the configuration for automatic firmware updates. If
Enable checkbox to allow an automatic firmware update when a new
IP address of the server where the firmware files reside. If a new
User ID required to access the FTP or TFTP server.
Protocol drop-down menu to specify the
FLASH medium used for the file update from the server. FLASH is
Switch Information
FTP, TFTP, HTTP, SFTP,
listed on the RFS7000, users can also auto-
FTP, TFTP, HTTP, SFTP,
FTP, TFTP, HTTP, SFTP,
3-39
or
or
or