Motorola RFS Series System Reference Manual page 195

State Displays the radio's current operational mode. If the radio is set as a Detector AP,
the state is "Detector", otherwise the state is "Normal".
VLAN Displays the name of the VLAN currently used with each Access Port radio.
4. Refer to the Properties
Desired Channel When the radio's channel is configured statically, the Actual Channel and Desired
Channel are the same. If using ACS (Automatic Channel Selection), the switch
selects a channel for the radio. The Desired Channel displays "ACS" and the
Actual channel displays the channel selected for the radio. When set to Random,
the applet determines the channel's designation.
Actual Channel When the radio's channel is configured statically, the Actual Channel and Desired
Channel are the same. If using ACS (Automatic Channel Selection), the switch
selects a channel for the radio. The Desired channel displays "ACS" and the
Actual Channel displays the channel selected for the radio.
Desired Power (dBm) Displays the configured power setting in dBm for the selected radio. In most
cases, the Desired Power and Actual Power are the same unless the desired
power level would put the radio's output power outside the accepted regulatory
compliance range.
Actual Power Displays the current power level in dBm for the selected radio. In most cases, the
Desired Power and Actual Power are the same unless the desired power level
would put the radio's output power outside the accepted regulatory compliance
range.
Placement When the radio is adopted using the default configuration, the power for the radio
can be defined as "Indoor" or "Outdoor." However, some countries have
restrictions for the use of outdoor radios. If using a value of "Outdoor", verify if it
is in compliance with the country of operation's regulatory restrictions.
Last Adopted Displays the time this radio was last adopted by the switch.
AP IP Address Mask Displays the net mask address associated with the selected Access Port IP
Address.
Voice Calls Displays the current number of active voice calls for the selected radio.
5. Click the Edit button to launch a screen used to configure radio-specific parameters. For more
information, see Editing AP Settings on page
6. Click the Delete button to remove a radio. However, before a radio can be removed, the radio's BSS
mapping must be removed.
7. Click the Add button to add a radio. The radio must be added before the radio can be adopted. For more
information, see Adding APs on page
8. Click the Reset button to reset an individual radio.
9. Click the Tools > button to displays a submneu with Reset,
Select the Reset option to reset the Access Port radio. Select the
channels and discover which radios are adopted and on what channel. ACS then analyzes the radios'
channels and moves the radio to the channel where it is least likely to have interference from the other
radios. Use the Export option to move the contents of the table to a Comma Separated Values file (CSV).
10.Select an AP from the table and click the
field for the following
4-97.
4-104.
AP Mesh
Run ACS, and Export
Run ACS Now
button to configure a mesh network.
4-93
Network Setup
options.
option to scan all