Motorola RFS Series System Reference Manual page 351

4. Enter the Multicast MAC Address
MAC address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
NOTE: To use the onboard SOLE engine to locate Aeroscout tags, site parameters, AP
location (Command Line Interface only) and Zone configuration (optional, Command Line
Interface only) must be configured.
5. Click the Apply button to save the
6. Click the Revert button to cancel any changes made within
back to the last saved configuration.
7. If the Multicast MAC Address
information will be displayed:
IP Address Displays the IP address of the external Aeroscout RTLS engine.
Port Displays the port number which the switch uses to connect to the external
Aeroscout RTLS engine.
No. of RX Msgs Displays the number of messages received by the switch from the external
Aeroscout RTLS engine.
Last Msg RX Time Displays the Date and Time that the last message was received from the external
Aeroscout RTLS engine.
No. of TX Msgs Displays the number of messages transmitted by the switch to the external
Aeroscout RTLS engine.
Last Msg TX Time Displays the Date and Time that the last message was sent to the external
Aeroscout RTLS engine.
No. of Tag Reports Displays the number of Tag Reports received from the external Aeroscout RTLS
engine.
8. To use the onboard SOLE engine to locate Aeroscout tags check the
immediately after checking the box.
9. If the onboard SOLE engine is enabled to locate Aeroscout tags, enter a
specify how often the known tags are located by the SOLE engine.
10.Click the Apply button to save the
11.Click the Revert button to cancel any changes made within
the last saved configuration.
used for all Aeroscout tags to send updates via multicast to the
Multicast MAC Address
is configured and Aeroscout support is enabled the following
Locate Interval value.
Switch Services
value.
Multicast MAC Address
Enable checkbox. This is enabled
Locate Interval
Locate Interval value and revert back to
5-69
value and revert
in seconds to