Motorola RFS Series System Reference Manual page 548

B-14 Motorola RF Switch System Reference Guide
1. Select System Configuration
2. Select the Auto Discovery Enable
Enabling auto discovery will allow the AAP to be detected by a switch once its connectivity medium
has been configured (by completing steps 3-6).
NOTE Auto discovery must be enabled for a switch to detect an AP.
3. Enter up to 12
The AAP will begin establishing a connection with the first addresses in the list. If unsuccessful, the AP
will continue down the list (in order) until a connection is established.
4. If a numerical IP address is unknown, but you know a switch's fully qualified domain name (FQDN), enter
the name as the
5. Select the Enable AP-Switch Tunnel
a secure VPN tunnel.
6. If using IPSec as the tunnel resource, enter the IPSec
7.
Click Apply to save the changes to the AAP setup.
NOTE The manual AAP adoption described above can also be conducted using
the Access Point's CLI interface using the admin(system.aapsetup)>
command.
B.4.1.2 Adopting an Adaptive AP Using a Configuration File
To adopt an AAP using a configuration file:
1. Refer to Adopting an Adaptive AP Manually
-> Adaptive AP Setup
checkbox.
Switch IP Addresses constituting the target switches available for AAP connection.
Switch FQDN value.
option to allow AAP configuration data to reach a switch using
from the Access Point's menu tree.
Passkey to ensure IPSec connectivity.
and define the AAP switch connection parameters.