Table of Contents
Advertisement
User's Manual — M68ICS08JB In-Circuit Simulator
1.1 Introduction
M68ICS08JB In-Circuit Simulator
MOTOROLA
This section provides general information about the Motorola M68ICS08JB
in-circuit simulator (JBICS).
The M68ICS08JB JBICS board is a stand-alone development and debugging
tool. It contains the hardware and software needed to develop and simulate
source code and to program Motorola's MC68HC908JB8 microcontroller unit
(MCU).
The JBICS and it's software form a complete editor, assembler, programmer,
simulator, and limited real-time input/output emulator for the MCU. When
connection is made between a host PC (personal computer) and target hardware
(your prototype product), actual inputs and outputs of the target system may be
used during code simulation.
The JBICS can interface with any IBM
later version) through connection of a single RS-232 serial port using a DB-9
serial cable.
Connection to the target system is accomplished by a ribbon cable, a Motorola
M6CLB05C flex cable, a MONO8 cable, or one of two DIP emulation cables
(low cost alternatives to the flex cable). The ribbon cable or flex cable or DIP
cable is used when an MCU is resident on the JBICS for emulation or
simulation, and the MONO8 cable is used to debug or program a target system's
MCU, directly, when the MCU resides on the target hardware.
General Information
Section 1. General Information
®
Windows 95
®
-based computer (or
User's Manual
11
Advertisement
Table of Contents
