Displaying Ospf Route Information - HP ProCurve 6200yl Multicast And Routing Manual

Displaying OSPF Route Information

To display OSPF route and other OSPF configuration information, enter show
ip ospf at any CLI level:
ProCurve# show ip ospf
OSPF Configuration Information
OSPF protocol
Router ID
Currently defined areas:
Area ID
--------------- ------ ------------- ------------ ---------------
backbone
10.3.16.0
10.3.32.0
Currently defined address ranges:
Area ID
--------------- ---------- --------------- --------------- ---------
10.3.16.0
OSPF interface configuration:
IP Address
--------------- --------------- -------- ----- ------ ----- ---
10.3.2.35
10.3.3.35
10.3.16.35
10.3.32.35
OSPF configured interface timers:
IP Address
--------------- ------- ---------- --------- ----------
10.3.2.35
10.3.3.35
10.3.16.35
10.3.32.35
OSPF configured virtual interfaces:
Area ID
--------------- --------------- ------ ------ ------ ------ ----------
10.3.16.0
10.3.16.0
Figure 5-26.Example of Output for Show IP OSPF
: enabled
: 10.0.8.35
Stub
Type Default Cost
normal 1
normal 1
normal 1
LSA Type IP Network
Summary 10.3.16.0
Admin
Area ID Status
backbone enabled
backbone enabled
10.3.16.0 enabled
10.3.32.0 enabled
Transit Retransmit Hello
Delay Interval
1 5
1 5
1 5
1 5
Authen Xmit
Router ID Type
10.0.8.33 none
10.0.8.36 none
Stub Stub
Summary LSA Metric Type
don't send ospf metric
don't send ospf metric
don't send ospf metric
Network Mask
255.255.255.0
Authen
Type Type
BCAST none
BCAST none
BCAST none
BCAST none
Dead
Interval Interval
10 40
10 40
10 40
10 40
Rxmt
Delay Intvl
1 5
1 5
IP Routing Features
Configuring OSPF
Advertise
yes
Cost Pri
1 1
1 1
1 1
1 1
Hello Dead
Intvl Interval
10 40
10 40
5-69