HP ProCurve 6200yl Multicast And Routing Manual page 296

Virtual Router Redundancy Protocol (VRRP)
Event Log Messages
Message
Vrid < vrid-# >, Vid < vid-# > recd pkt with
bad IP-TTL
Vrid < vrid-# >, Vid < vid-# > recd pkt with
checksum error
Vrid < vrid-# >, Vid < vid-# > recd pkt with
invalid auth type
Vrid < vrid-# >, Vid < vid-# > recd pkt with
IP address mismatch
Vrid < vrid-# >, Vid < vid-# > recd pkt with
invalid type
VRRP has been disabled on this router
VRRP has been enabled on this router
6-36
Meaning
— Continued from Previous Page —
A VRRP packet was received by the indicated VR on the
indicated VLAN with an IP TTL value not equal to 255.
The indicated VR on the indicated VLAN has received a
VRRP advertisement packet with a checksum error. The VR
has therefore dropped that packet.
Indicates the VR has received a VRRP packet with an
authentication type set to a value other than the 0, 1, or 2
(allowed by RFC 3768) and has dropped the packet.
A VRRP packet was received by the indicated VR on the
indicated VLAN with virtual IP address(es) that did not
match the virtual IP addresses configured on the receiver
VR.
A VRRP packet was received by the indicated VR on the
indicated VLAN with the packet type not equal to 1.
VRRP was disabled at the global config level.
VRRP was enabled at the global config level.