IP Routing Features
Configuring OSPF
ProCurve# show ip ospf interface 10.3.18.36
OSPF Interface Status for 10.3.18.36
IP Address
Area ID
State
: BDR
Cost
: 1
Type
: BCAST
Transit Delay
Hello Interval
Designated Router : 10.3.18.34
Backup Desig. Rtr : 10.3.18.36
Figure 5-17. Example of Show IP OSPF Interface < ip-addr > Output
5-60
Displaying OSPF Interface Information for a Specific VLAN
or IP Address
To display OSPF interface information for a specific VLAN or IP address, enter
show ip ospf interface < ip-addr > at any CLI level. For example:
: 10.3.18.36
: 10.3.16.0
: 1
: 10
Syntax: show ip ospf interface [vlan < vlan-id > | < ip-addr >]
The OSPF interface display for a specific VLAN or IP address has the same
information as the non-specific show ip ospf interface command for the IP
Address, Area ID, Status, State, Auth-type, Cost, and Priority fields. See the
information for the general command above for definitions of these fields.
The show ip ospf interface command for a specific VLAN or IP address shows
the following additional information:
Table 5-10. CLI Display of OSPF Interface Information – VLAN or IP Address
This Field...
Displays...
Type
Will always be BCAST for interfaces on this routing switch.
Point-to-point or NBMA (frame relay or ATM) type interfaces
are not supported on the switches covered in this guide.
Transit Delay
Configured transit delay for this interface.
Retrans Interval
Configured retransmit interval for this interface.
Status
: enabled
Auth-type : none
Priority
: 1
Retrans Interval
Rtr Dead Interval : 40
Events
: 5
: 3