HP ProCurve 6200yl Multicast And Routing Manual page 39

N o t e
If you disable IGMP on a VLAN and then later re-enable IGMP on that VLAN,
the switch restores the last-saved IGMP configuration for that VLAN. For more
on how switch memory operates, refer to the chapter titled "Switch Memory
and Configuration" in the Management and Configuration Guide for your
switch.
You can also combine the ip igmp command with other IGMP-related com­
mands, as described in the following sections.
Configuring Per-Port IGMP Traffic Filters.
Syntax: vlan < vid > ip igmp [auto < port-list > | blocked < port-list > | forward < port-list >]
Used in the VLAN context, this command specifies how each
port should handle IGMP traffic. (Default: auto.)
Note: Where a static multicast filter is configured on a port,
and an IGMP filter created by this command applies to the
same port, the IGMP filter overrides the static multicast filter
for any inbound multicast traffic carrying the same multicast
address as is configured in the static filter. (Refer to the section
titled "Filter Types and Operation" in the "Port Traffic
Controls" chapter of the Management and Configuration
Guide for your switch.
For example, suppose you wanted to configure IGMP as follows for VLAN 1
on the 100/1000T ports on a module in slot 1:
Ports A1-A2 auto
Ports A3-A4 forward
Ports A5-A6 blocked
Depending on the privilege level, you could use one of the following com­
mands to configure IGMP on VLAN 1 with the above settings:
ProCurve(config)# vlan 1 ip igmp auto a1,a2 forward a3,a4
blocked a5,a6
ProCurve(config)# ip igmp auto a1,a2 forward a3,a4 blocked
a5,a6
Multimedia Traffic Control with IP Multicast (IGMP)
Filter multicast traffic. Forward IGMP traffic to hosts on these
ports that belong to the multicast group for which the traffic is
intended. (Also forward any multicast traffic through any of
these ports that is connected to a multicast router.)
Forward all multicast traffic through this port.
Drop all multicast traffic received from devices on these ports,
and prevent any outgoing multicast traffic from moving through
these ports.
CLI: Configuring and Displaying IGMP
2-9