Creating A Vr And Entering The Vr Context - HP ProCurve 6200yl Multicast And Routing Manual

For example, the following commands enable VRRP at the global configura­
tion level and then display the current global VRRP configuration:
ProCurve(config)# router vrrp
ProCurve(config)# show vrrp config global
VRRP Global Configuration Information
VRRP Enabled
Traps Enabled
Figure 6-5. Example of Enabling and Displaying the Global VRRP Configuration

Creating a VR and Entering the VR Context

This command is used to create (or delete) a VR instance and to enter a VR
context to do further configuration steps.
Syntax: [no] vrrp vrid < 1 - 255 >
Used in the VLAN interface context to create a virtual router
(VR) instance and to enter the context of the new VR. It is also
used to enter the context of an existing VR, and is the method
used for accessing a VR for configuration purposes. You can
configure up to 32 VRs on a multinetted VLAN.
The VLAN interface must be IP enabled.
For example, to create VR 1 in VLAN 10 and enter the VR context, you would
execute the following command:
ProCurve(vlan-10)# vrrp vrid 1
ProCurve(vlan-10-vrid-1)#
Virtual Router Redundancy Protocol (VRRP)
: Yes
: Yes
Configuring VRRP
6-19