HP ProCurve 6200yl Multicast And Routing Manual page 74

PIM-DM (Dense Mode)
Displaying PIM Data and Configuration Settings
3-24
Syntax: show ip mroute [ interface < vid >]
Lists these settings:
VLAN: The VID specified in the command.
Protocol Identity: PIM-DM only.
TTL: The time-to-live threshold for packets forwarded through
this VLAN. When configured, the routing switch drops multi-
cast packets having a TTL lower than this value. (When a
packet arrives, the routing switch decrements it's TTL by 1,
then compares the decremented packet TTL to the value set by
this command.) A TTL Threshold setting of 0 (the default)
means all multicast packets are forwarded regardless of the
TTL value they carry. A multicast packet must have a TTL
greater than 1 when it arrives at the routing switch. Other-
wise the routing switch drops the packet instead of forward­
ing it on the VLAN.
ProCurve(config)# show ip mroute interface 29
IP Multicast Interface
VLAN : 29
Protocol : PIM-DM
TTL Threshold : 0
Figure 3-8. Example of the Above Command on Routing Switch "#2" in Figure 3-4
on Page 3-20