Changing Vr Advertisement Interval And Source Ip Address - HP ProCurve 6200yl Multicast And Routing Manual

Procurve series switch
Hide thumbs Also See for ProCurve 6200yl:
Table of Contents

Advertisement

Virtual Router Redundancy Protocol (VRRP)
Configuring VRRP
6-22
Reconfiguring the Priority for a Backup. When you configure a Backup
in a VR, it is given a default priority of 100. This command is intended for use
where it is necessary to establish a precedence among the Backup routers on
the same network or subnet in a given VR.
Syntax: priority < 1 - 254 >
Used in a VR context of a VLAN where the router is configured
as a Backup. This command changes the Backup's priority
and is used to establish the precedence of a Backup where there
are multiple Backups belonging to the same network or subnet.
Also, the VR instance must be disabled (the default VR state)
when using this command.
Note: An Owner is automatically assigned the highest prior­
ity, 255, which cannot be changed unless the Owner status is
reconfigured to Backup.
(Range: 1 - 254, where 1 is the lowest precedence; Default: 100)

Changing VR Advertisement Interval and Source IP Address

The advertisement interval is used in one of two ways, depending on whether
a VRRP router is operating as a Master or a Backup.
Syntax: advertise-interval < 1 - 255 >
When a VRRP router is operating as Master, this value
specifies the interval at which the router sends an
advertisement notifying the other VRRP routers on the
network or subnet that a Master is active.
When a VRRP router is operating as a Backup, it uses
this value to calculate a timeout interval ( 3 x advt­
interval).
The VR instance must be disabled (the default VR state) when
using this command.
(Range: 1 - 255 seconds; Default: 1 second)
For information on advertisements and advertisement inter­
vals, see "Function of the VRRP Advertisement" on page 6-9
Note: All VRRP routers belonging to the same VR must be
configured with the same advertisement interval. As
required in RFC 3768, if a locally configured advertise­
ment interval does not match the interval received in an
inbound VRRP packet, then the VR drops that packet.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProCurve 6200yl and is the answer not in the manual?

This manual is also suitable for:

Procurve 5400zlProcurve 3500yl

Table of Contents