Displaying General Rip Information - HP ProCurve 6200yl Multicast And Routing Manual

Displaying General RIP Information

To display general RIP information, enter show ip rip at any context level. The
resulting display will appear similar to the following:
Figure 5-3.Example of General RIP Information Listing
The display is a summary of Global RIP information, information about
interfaces with RIP enabled, and information about RIP peers. The following
fields are displayed:
■ RIP protocol – Status of the RIP protocol on the router. RIP must be
enabled here and on the VLAN interface for RIP to be active. The default
is disabled.
Auto-summary – Status of Auto-summary for all interfaces running RIP.
■
If auto-summary is enabled, then subnets will be summarized to a class
network when advertising outside of the given network.
■ Default Metric – Sets the default metric for imported routes. This is the
metric that will be advertised with the imported route to other RIP peers.
A RIP metric is a measurement used to determine the 'best' path to
network; 1 is the best, 15 is the worse, 16 is unreachable.
Route changes – The number of times RIP has modified the routing
■
switch's routing table.
IP Routing Features
Configuring RIP
5-29