HP ProCurve 6200yl Multicast And Routing Manual page 148

PIM-SM (Sparse Mode)
Displaying PIM-SM Data and Configuration Settings
ProCurve(config)# show ip pim interface 1
PIM Interface
VLAN : 1
IP Address : 10.1.10.1
Mode : sparse
Designated Router : 10.1.10.1
Hello Interval (sec)
Hello Delay (sec)
Override Interval (msec)
Propagation Delay (msec)
Neighbour Timeout
Figure 4-17. Example Showing a PIM-SM Interface Configured on VLAN 1
Table 4-1. PIM Interface Configuration Settings
Field
VLAN
IP
Mode
Hello Interval (sec)
Hello Delay
Override Interval (msec)
Propagation Delay (msec)
Neighbor Timeout
LAN Prune Delay
LAN Delay Enabled
DR Priority
4-56
: 30
: 5
: 2500
: 500
: 180
Default Control Command
n/a vlan < vid > ip pim
n/a vlan < vid > ip pim < all | ip-addr >
dense n/a; PIM Dense only
300 ip pim hello interval < 5 - 30 >
5 The router includes this value in the "Hello" packets the it sends to neighbor
routers. Neighbor routers use this value to determine how long to wait for another
Hello packet from the router. Refer to "Changing the Interval for PIM-SM
Neighbor Notification" on page 4-30.
2500 vlan < vid > ip pim override-interval < 500 - 6000 >
500 vlan < vid > ip pim propagation-delay < 250-2000 >
180 ip pim-sparse nbr-timeout < 60 - 65535 >
Yes vlan < vid > ip pim lan-prune-delay
Yes
No Shows if all multicast routers on the current VLAN interface enabled LAN-
prune-delay. Otherwise shows
ip pim-sparse dr-priority < 0 - 4294967295 >
1
Lan Prune Delay
Lan Delay Enabled
DR Priority
No
.
: Yes
: No
: 1