Vlan Context Commands For Configuring Pim-Sm; Enabling Or Disabling Igmp In A Vlan - HP ProCurve 6200yl Multicast And Routing Manual

PIM-SM (Sparse Mode)
Configuring PIM-SM on the Router
4-28
ProCurve(config)# show running-config
Running configuration:
; J8693A Configuration Editor; Created on release #K.11.XX
hostname "ProCurve"
module 2 type J8705A
module 1 type J8702A
ip routing
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged A1-A24, B1-B24
ip address 10.10.10.1 255.255.255.0
exit
ip multicast-routing
router rip
exit
router pim
exit
Figure 4-5. Displaying the Running Configuration

VLAN Context Commands for Configuring PIM-SM

PIM-SM must be configured on at least one VLAN in the router before it can
be configured as a C-BSR or a C-RP.

Enabling or Disabling IGMP in a VLAN

IGMP must be enabled in VLANs on edge routers where multicast receivers
(end points) are connected and will be requesting to join multicast groups.
Syntax: [no] ip igmp
[no] vlan < vid > ip igmp
Enables or disables IGMP operation in the current VLAN.
Configuring IGMP on the router is required in VLANs sup-
porting edge router operation. For more information, refer to
the chapter titled "Multimedia Traffic Control with IP Multi-
cast (IGMP)" in this guide.
Global Routing Configuration
for PIM-SM Support
Note: Either RIP, OSPF, or
static routing can be used for
a routing protocol.