Viewing The Current Dhcp Relay Configuration - HP ProCurve 6200yl Multicast And Routing Manual

IP Routing Features
Configuring DHCP Relay

Viewing the Current DHCP Relay Configuration

Determining the DHCP Relay Setting. Use show config (or show running
for the running-config file) to list the current DHCP Relay setting. Note that
because DHCP Relay is enabled in the default configuration, it does not appear
in these listings unless it is disabled.
Non-Default DHCP-Relay Setting
Figure 5-38. Example of Startup-Config Listing with DHCP-Relay Disabled
Listing the Currently Configured DHCP Helper Addresses.
Syntax: show ip helper-address < vlan-id >
This command shows the currently configured IP Helper addresses, regard-
less of whether DHCP-Relay is enabled. For example:
Figure 5-39. Example of Listing for IP Helper Addresses
5-93