HP ProCurve 6200yl Multicast And Routing Manual page 114

PIM-SM (Sparse Mode)
Configuration Steps for PIM-SM
4-22
4. This is an optional step in the initial PIM-SM configuration. (Refer to the
preceding Note.) In the pim-sparse context of a given VLAN on which PIM­
SM is enabled, change one or more of the traffic control settings listed in
the following table. (Note that some VLAN context control settings apply
to both PIM-SM and PIM-DM.)
Features Accessed in
VLAN-< vid >-pim-sparse
Context
ip-addr
(page 4-29)
hello-interval*
(page 4-30)
hello-delay*
(page 4-31)
nbr-timeout
(page 4-31)
lan-prune-delay*
(page 4-32)
override-interval*
(page 4-33)
propagation-delay*
(page 4-33)
dr-priority
(page 4-33)
*Applies to both PIM-SM and PIM-DM operation.
Operation
Sets or resets the source IP address for PIM-SM packets
sent out on the interface. Also enables PIM-SM on the
any
interface. (Default: )
Resets the interval between transmitted PIM Hello packets
on the interface. (Default: 30 seconds)
Resets the maximum delay for transmitting a triggered PIM
Hello packet on the interface. (Default: 5 seconds)
Resets the neighbor loss time interval for the interface.
(Default: 180 seconds)
Enables or disables the LAN prune delay feature on the
on
interface. (Default: )
Resets the override interval of the LAN Prune Delay
configured on the interface. (Default: 2500 milliseconds)
Resets the delay interval for triggering LAN Prune Delay
packets on the interface. (Default: 500 milliseconds)
Resets the priority of the interface in the Designated Router
election process. (Default: 1) If you want one router on a
given VLAN to have a higher priority for DR than other
routers on the same VLAN, use the dr-priority command to
reconfigure the DR priority setting as needed. Otherwise, the
highest DR priority among multiple routers on the same
VLAN interface is assigned to the router having the highest
source IP address for PIM-SM packets on that interface.