Enabling Ip Rip On A Vlan; Changing The Rip Type On A Vlan Interface; Changing The Cost Of Routes Learned On A Vlan Interface - HP ProCurve 6200yl Multicast And Routing Manual

N o t e
N o t e
IP routing must be enabled prior to enabling RIP. The first command in the
preceding sequence enables IP routing.

Enabling IP RIP on a VLAN

To enable RIP on all IP addresses in a VLAN, use ip rip in the VLAN context.
To enable RIP on a specific IP address in a VLAN, use ip rip < ip-addr > in the
VLAN context.

Changing the RIP Type on a VLAN Interface

When you enable RIP on a VLAN interface, RIPv2-only is enabled by default.
You can change the RIP type to one of the following on an individual VLAN
interface basis:
Version 1 only
■
■ Version 2 only (the default)
Version 1 - or - version 2
■
To change the RIP type supported on a VLAN interface, enter commands such
as the following:
ProCurve(config)# vlan 1
ProCurve(vlan-1)# ip rip v1-only
ProCurve(vlan-1)# exit
ProCurve(config)# write memory
Syntax: [no] ip rip < v1-only | v1-or-v2 | v2-only >

Changing the Cost of Routes Learned on a VLAN Interface

By default, the switch interface increases the cost of a RIP route that is learned
on the interface. The switch increases the cost by adding one to the route's
metric before storing the route.
You can change the amount that an individual VLAN interface adds to the
metric of RIP routes learned on the interface.
RIP considers a route with a metric of 16 to be unreachable. Use this metric
only if you do not want the route to be used. In fact, you can prevent the switch
from using a specific interface for routes learned though that interface by
setting its metric to 16.
IP Routing Features
Configuring RIP
5-25