HP ProCurve 6200yl Multicast And Routing Manual page 89

Message
I/F removal with IP < ip-addr > on vid
< vlan-id > (<counter>)
MCAST flow < multicast-address > < source-
address > not rteing (rsc low)
(<counter>)
MCAST MAC add for < mac-address > failed
(<counter>)
Multicast Hardware Failed to
Initialize (<counter>)
No IP address configured on VID
< vlan-id > (<dup-msg-cnt>)
Pkt dropped from < ip-address >,(< cause >)
vid < vlan-id > (<counter>)
Pkt rcvd with a cksum error from
< ip-addr > (<counter>)
Rcvd incorrect hello from < ip-addr >
(<counter>)
Rcvd < text-str > pkt with bad len from
< ip-addr > (<counter>)
Rcvd hello from < ip-address > on vid
< vlan-id > (<counter>)
Messages Related to PIM Operation
Meaning
Indicates that a PIM interface (VLAN) has been removed
from the router as a result of an IP address change or
removal.
The indicated multicast flow is not routing. The routing
switch is low on memory resources as a result of too many
flows for the number of configured VLANs. Remedies
include one or more of the following:
• Reduce the number of configured VLANs by moving
some VLANs to another router.
• Free up system resources by disabling another feature,
such as one of the spanning-tree protocols or either the
RIP or the OSPF routing protocol. (Unless you are using
static routes, you will need to retain a minimum of one
unicast routing protocol.) Another option that may help
is to reduce the number of configured QoS filters.
• Move some hosts that create multicast demand to
another router.
Indicates a hardware problem. Check the cabling and router
ports.
Indicates a hardware failure that halts hardware
processing of PIM traffic. The software will continue to
process PIM traffic at a slower rate. Contact your ProCurve
customer care center.
PIM has detected a VLAN without an IP address. Configure
an IP address on the indicated VLAN.
A PIM packet from < ip-address > was dropped due to one
of the following causes:
• No PIM interface on the VLAN
• Bad packet length
• Bad IP header length
• Bad IP total length
A packet having a checksum error was received from < ip­
address >. Check the cabling and ports on the local and the
remote routers.
Indicates receipt of a malformed hello packet. (That is, the
packet does not match the current specification.) Ensure
that compatible versions of PIM-DM are being used.
A peer router may be sending incorrectly formatted PIM
packets.
Indicates a misconfiguration where two routers are directly
connected with different subnets on the same connected
interface.
PIM-DM (Dense Mode)
3-39