HP ProCurve 6200yl Multicast And Routing Manual page 141

ProCurve(config)# show ip mroute 234.43.209.12 192.168.1.0
IP Multicast Route Entry
Group Address
Source Address : 192.168.1.0
Source Mask
Neighbor
VLAN
Up Time (sec)
Expire Time (sec)
Multicast Routing Protocol : PIM-SM
Unicast Routing Protocol
Downstream Intefaces
VLAN State
---- ---------- ----------------- ------------------
2 forwarding 757
Figure 4-10. Example Showing Route Entry Data for a Specific Multicast Group
Unicast Routing Protocol: Identifies the IP routing protocol
through which the router learned the upstream interface for
the current multicast flow. The listed protocol will be either
RIP, OSPF, or Static Route.
Downstream Interfaces:
VLAN: Lists the VID of the VLAN the router is using to send the
outbound packets of the current multicast flow to the next-hop
router.
State: Indicates whether the outbound VLAN and next-hop
router for the current multicast flow are receiving datagrams.
– Pruned: The router has not detected any joins from the
current multicast flow and is not currently forwarding
datagrams in the current VLAN.
Forwarding: The router has received a join for the current
–
multicast flow and is forwarding
datagrams in the current VLAN.
Up Time (Sec): Indicates the elapsed time in seconds since the
router learned the displayed information about the current
multicast flow.
: 234 .43.209.12
: 255.255.255.0
: 192.168.1.3
: l
:7 57
: 173
: RIP
Up Time (sec)
Displaying PIM-SM Data and Configuration Settings
This Neighbor field indicates that the router is receiving
multicast traffic from a neighboring PIM router. A blank
Neighbor field indicates that the multicast server is directly
connected to the router instead of another PIM router.
E xpire Time (sec)
12
PIM-SM (Sparse Mode)
4-49