Overview Of Ip Routing - HP ProCurve 6200yl Multicast And Routing Manual

Overview of IP Routing

The switches covered in this guide offer the following IP routing features, as
noted:
IP Static Routes – up to 256 static routes
■
■ RIP (Router Information Protocol) – supports RIP Version 1, Version 1
compatible with Version 2 (default), and Version 2
OSPF (Open Shortest Path First) – the standard routing protocol for
■
handling larger routed networks
IRDP (ICMP Router Discovery Protocol) – advertises the IP addresses of
■
the routing interfaces on this switch to directly attached host systems
■ DHCP Relay – allows you to extend the service range of your DHCP
server beyond its single local network segment
Throughout this chapter, the switches covered in this guide are referred to as
"routing switches". When IP routing is enabled on your switch, it behaves just
like any other IP router.
Basic IP routing configuration consists of adding IP addresses, enabling IP
routing, and, enabling a route exchange protocol, such as Routing Information
Protocol (RIP).
For configuring the IP addresses, refer to the chapter titled "Configuring IP
Addresses" in the Management and Configuration Guide for your switch.
The rest of this chapter describes IP routing and how to configure it in more
detail. Use the information in this chapter if you need to change some of the
IP parameters from their default values or you want to view configuration
information or statistics.
IP Routing Features

Overview of IP Routing

5-3