Cisco ASR 9000 Series Configuration Manual page 317

RADIUS Attributes
Cause Code
195
600
601
602
603
604
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Value
Call-Duration
VPN-User-Disconnect
VPN-Carrier-Loss
VPN-No-Resources
VPN-Bad-Control-Packet
VPN-Admin-Disconnect
RADIUS Disconnect-Cause Attributes
Description
Disconnected because the
maximum duration of the call was
exceeded.
Call disconnected by client
(through PPP).
Code is sent if the LNS receives a
PPP terminate request from the
client.
Loss of carrier. This can be the
result of a physical line going dead.
Code is sent when a client is unable
to dial out using a dialer.
No resources available to handle
the call.
Code is sent when the client is
unable to allocate memory (running
low on memory).
Bad L2TP or L2F control packets.
This code is sent when an invalid
control packet, such as missing
mandatory Attribute-Value pairs
(AVP), from the peer is received.
When using L2TP, the code will
be sent after six retransmits; when
using L2F, the number of
retransmits is user configurable.
VPN-Tunnel-Shut will be
Note
sent if there are active
sessions in the tunnel.
Administrative disconnect. This
can be the result of a VPN soft
shutdown, which is when a client
reaches maximum session limit or
exceeds maximum hopcount.
Code is sent when a tunnel is
brought down by issuing the clear
vpdn tunnel command.
4.3.x
305