Specifying A Utilization Threshold - Cisco ASR 9000 Series Configuration Manual

Configuring Subscriber Features
Command or Action
Step 3
address-range low_ip_address high_ip_address
Example:
RP/0/RSP0/CPU0:router(config-pool-ipv6)# address-range
1234::2 1234::3e81
Step 4
Use the commit or end command.
Specifying a Range of IPv6 Addresses: An example
configure
pool vrf vrf1 ipv6 addr_vrf
address-range 1234::2 1234::3e81
!
!
end

Specifying a Utilization Threshold

Perform this task to specify a utilization threshold for a specific VRF in the pool IPv6 submode.
SUMMARY STEPS
1. configure
2. pool vrf vrf_name ipv6 ipv6-pool-name
3. prefix-length value
4. network subnet
5. utilization-mark high value low value
6. Use the commit or end command.
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Specifying a Utilization Threshold
Purpose
Specifies the range of IPv6 addresses within a pool.
Multiple address-ranges are allowed within a pool.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
4.3.x
253