Igmp To Unicast Qos Shaper Correlation - Cisco ASR 9000 Series Configuration Manual

Configuring Subscriber Features
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 dynamic-template
Example:
RP/0/RSP0/CPU0:router(config)# dynamic-template
Step 3 type ppp dynamic-template name
Example:
RP/0/RSP0/CPU0:router(config-dynamic-template)# type
ppp foo
Step 4 multicast ipv4 <qos-correlation | passive>
Example:
RP/0/RSP0/CPU0:router(config-dynamic-template-type)#
multicast ipv4 qos-correlation
Step 5
Use the commit or end command.
Configuring Multicast HQOS Correlation Mode: An example
dynamic-template type ppp foo
multicast ipv4 qos-correlation
!
!
end

IGMP to Unicast QoS Shaper Correlation

The Unicast QoS Shaper correlation feature configures the bandwidth profiles for the multicast flows and
allows the IGMP messages to derive the multicast bandwidth usage for each subscriber. On the PPPoE
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
IGMP to Unicast QoS Shaper Correlation
Purpose
Enters global configuration mode.
Enter the dynamic-template configuration mode.
Enters the ppp type mode to configure igmp for
subscriber interfaces.
Configures the subscriber either in the QoS-correlation
mode (IGMP-HQOS correlation), or passive mode
(multicast forwarding).
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
4.3.x
239