Specifying The Lease Limit For A Remote-Id - Cisco ASR 9000 Series Configuration Manual

Specifying DHCP Lease Limit
Command or Action
Specifying the Lease Limit for a Circuit-ID: An example
configure
dhcp ipv4
profile profile1 proxy
limit lease per-circuit-id 1000
!
!
end

Specifying the Lease Limit for a Remote-ID

Perform this task to specify the lease limit for each Remote-ID.
SUMMARY STEPS
1. configure
2. dhcp ipv4
3. profile profile-name proxy
4. limit lease per-remote-id value
5. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
dhcp ipv4
Example:
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
Step 3 profile profile-name proxy
Example:
RP/0/RSP0/CPU0:router(config-dhcpv4)# profile
profile1 proxy
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
134
Establishing Subscriber Sessions
Purpose
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
Purpose
Enters global configuration mode.
Enters the IPv4 DHCP configuration mode.
Creates a DHCP profile.
OL-28375-03