Specifying The Lease Limit For An Interface - Cisco ASR 9000 Series Configuration Manual

Establishing Subscriber Sessions
Command or Action
Step 4
limit lease per-remote-id value
Example:
RP/0/RSP0/CPU0:router(config-dhcpv4-proxy-profile)#
limit lease per-remote-id 1340
Step 5 Use the commit or end command.
Specifying the Lease Limit for a Remote-ID: An example
configure
dhcp ipv4
profile profile1 proxy
limit lease per-remote-id 1340
!
!
end

Specifying the Lease Limit for an Interface

Perform this task to specify the lease limit for each interface.
SUMMARY STEPS
1. configure
2. dhcp ipv4
3. profile profile-name proxy
4. limit lease per-interface value
5. Use the commit or end command.
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Specifying DHCP Lease Limit
Purpose
Specifies the lease limit for a Remote-ID that is applied
to an interface.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
4.3.x
135