Cisco ASR 9000 Series Configuration Manual page 103

Establishing Subscriber Sessions
Command or Action
Step 9
initiator unclassified-source
Example:
RP/0/RSP0/CPU0:router(config-subif-ipsub-ipv4-l2conn)#
initiator unclassified-source
or
Example:
RP/0/RSP0/CPU0:router(config-subif-ipsub-ipv6-l2conn)#
initiator unclassified-source
Step 10 Use the commit or end command.
Enabling IPoE Subscribers on an Access Interface: Examples
configure
interface Bundler-Ether400.12
arp learning disable
ipv4 address 3.5.1.1 255.255.0.0
service-policy type control subscriber PL4
encapsulation dot1q 40
ipsubscriber ipv4 l2-connected
initiator dhcp
initiator unclassified-source
!
!
end
configure
interface Bundler-Ether400.12
arp learning disable
ipv6 address 4444:34
service-policy type control subscriber PL4
encapsulation dot1q 40
ipsubscriber ipv6 l2-connected
initiator dhcp
initiator unclassified-source
!
!
end
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Enabling IPoE Subscribers on an Access Interface
Purpose
Initiates a class for DHCP for an IP session initiated by
DHCP.
If multiple initiators are used, use a policy or
Note
class map to prevent overlap of the IP addresses
for the different sources.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
4.3.x
91