Cisco ASR 9000 Series Configuration Manual page 175

Establishing Subscriber Sessions
Command or Action
Example:
RP/0/RSP0/CPU0:router(config-if)# encapsulation
ambiguous dot1q any
RP/0/RSP0/CPU0:router(config-if)# encapsulation
ambiguous dot1q 14 second-dot1q 100-200
RP/0/RSP0/CPU0:router(config-if)# encapsulation
ambiguous dot1q any second-dot1q any
RP/0/RSP0/CPU0:router(config-if)# encapsulation
ambiguous dot1ad 14 dot1q 100,200,300-400
Step 4
ipv4 | ipv6address source-ip-address destination-ip-address
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 address
2.1.12.1 255.255.255.0
RP/0/RSP0/CPU0:router(config-if)# ipv6 address
1:2:3::4 128
Step 5 service-policy type control subscriber policy_name
Example:
RP/0/RSP0/CPU0:router(config-if)# service-policy type
control subscriber PL1
Step 6
ipsubscriber { ipv4|ipv6 } l2-connected
Example:
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv4
l2-connected
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv6
l2-connected
Step 7
initiator dhcp
Example:
RP/0/RSP0/CPU0:router(config-if)# initiator dhcp
Step 8 Use the commit or end command.
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Purpose
Configures the IPv4 or IPv6 protocol address.
Applies a policy-map to an access interface where the
policy-map was previously defined with the specified
PL1 policy_name.
Enables l2-connected IPv4 or IPv6 IP subscriber.
Enables initiator DHCP on the IP subscriber.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
DHCPv6 Features
4.3.x
163