Specifying A Set Of Addresses Or Prefixes Inside A Subnet - Cisco ASR 9000 Series Configuration Manual

Specifying a Set of Addresses or Prefixes Inside a Subnet

Command or Action
Specifying the Length of the Prefix that is Assigned to the Clients: An example
configure
pool vrf vrf1 ipv6 prefix_vrf
prefix-length 64
prefix-range 9fff:1:: 9fff:1:0:3e7f::
!
!
end
Specifying a Set of Addresses or Prefixes Inside a Subnet
Perform this task to specify a set of addresses or prefixes inside a subnet in the pool IPv6 configuration
submode.
SUMMARY STEPS
1. configure
2. pool vrf vrf_name ipv6 ipv6-pool-name
3. prefix-length value
4. network subnet
5. utilization-mark high value low value
6. exclude low_ip_address high_ip_address
7. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
256
Configuring Subscriber Features
Purpose
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
Purpose
Enters global configuration mode.
OL-28375-03