Specifying A Range Of Ipv6 Addresses - Cisco ASR 9000 Series Configuration Manual

Specifying a Range of IPv6 Addresses

Command or Action
Configuring the Subnet Number and Mask for an Address Pool: An example
configure
pool vrf default ipv6 test
prefix-length 120
network 1101:1::/114
utilization-mark high 70 low 30
exclude 1101:1::100 ::
!
!
end
Specifying a Range of IPv6 Addresses
Perform this task to specify a range of IPv6 addresses within a pool.
SUMMARY STEPS
1. configure
2. pool vrf vrf_name ipv6 ipv6-pool-name
3. address-range low_ip_address high_ip_address
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 pool vrf vrf_name ipv6 ipv6-pool-name
Example:
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv6
addr_vrf
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
252
Configuring Subscriber Features
Purpose
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
Purpose
Enters global configuration mode.
Creates the IPv6 pool name for a specific VRF and
enters the pool IPv6 configuration submode.
OL-28375-03