Cisco ASR 9000 Series Configuration Manual page 148

Specifying DHCP Lease Limit
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 dhcp ipv4
Example:
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
Step 3 profile profile-name proxy
Example:
RP/0/RSP0/CPU0:router(config-dhcpv4)# profile
profile1 proxy
Step 4 limit lease per-interface value
Example:
RP/0/RSP0/CPU0:router(config-dhcpv4-proxy-profile)#
limit lease per-interface 2400
Step 5
Use the commit or end command.
Specifying the Lease Limit for an Interface: An example
configure
dhcp ipv4
profile profile1 proxy
limit lease per-interface 2400
!
!
end
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
136
Establishing Subscriber Sessions
Purpose
Enters global configuration mode.
Enters the IPv4 DHCP configuration mode.
Creates a DHCP profile.
Specifies the lease limit for each interface.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
OL-28375-03