Configuring Service-Policy And Applying Subscriber Settings Through Dynamic Template - Cisco ASR 9000 Series Configuration Manual

Configuring Service-policy and Applying Subscriber Settings Through Dynamic Template

Command or Action
Example:
RP/0/RSP0/CPU0:router(config-pmap)# class
class-default
Step 7 service-policy q_child_out
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)#
service-policy q_child_out
Step 8 Use the commit or end command.
Configuring Subscriber Policy through CLI and Applying through RADIUS: Examples
configure
policy-map type qos q_in
class class-default
end
\\the following procedure is ran in RADIUS
Configuring Service-policy and Applying Subscriber Settings Through Dynamic
Template
Perform this task to deploy the QoS policy using CLI commands. In this task, subscriber settings are applied
using a dynamic template.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
178
Service-Type = Outbound-User
Cisco-avpair = "ip:keepalive=protocol arp attempts 5 interval 15",
Cisco-avpair = "ipv4:ipv4-mtu=750",
Cisco-avpair = "ipv4:ipv4-unnumbered=Loopback0",
Cisco-avpair = "subscriber:sub-qos-policy-in=q_in",
Cisco-avpair = "subscriber:sub-qos-policy-out=q_out",
Idle-Timeout = 1000,
Session-Timeout = 5000
Purpose
You can configure only the class-default class in a parent
Note
policy. Do not configure any other traffic class.
Applies a bottom-level policy to the top-level class-default class.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Deploying the Quality of Service (QoS)
OL-28375-03