Cisco ASR 9000 Series Configuration Manual page 223

Deploying the Quality of Service (QoS)
SUMMARY STEPS
1. configure
2. interface type
3. service-policy input service-policy-name
4. service-policy output service-policy-name
5. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 interface type
Example:
RP/0/RSP0/CPU0:router(config)# interface
Bundle-Ether18.203
Step 3 service-policy input service-policy-name
Example:
RP/0/RSP0/CPU0:router(config-subif)#
service-policy input mark
Step 4 service-policy output service-policy-name
Example:
RP/0/RSP0/CPU0:router(config-subif)#
service-policy output metering
Step 5
Use the commit or end command.
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Configuring VLAN Policy on an Access Interface
Purpose
Enters global configuration mode.
Configures subscribers on the Bundle-Ether access interface.
Configures the ingress VLAN QoS policy on the access-interface.
Configures the egress VLAN QoS policy on the access-interface.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
4.3.x
211