Configuring Policy Map For Http Redirect - Cisco ASR 9000 Series Configuration Manual

Configuring Subscriber Features
Command or Action
Configuring Class Maps for HTTP Redirection: An example
configure
class-map type traffic [match-any | match-all] <open-garden-class>
match [not] access-group ipv4 allow-acl
end-class-map
class-map type traffic [match-any | match-all] <http-redirect-class>
match [not] access-group ipv4 redirect-acl
end-class-map
!
!
!
end
configure
class-map type traffic [match-any | match-all] <open-garden-class>
match [not] access-group ipv6 allow-acl
end-class-map
class-map type traffic [match-any | match-all] <http-redirect-class>
match [not] access-group ipv6 redirect-acl
end-class-map
!
!
!
end

Configuring Policy Map for HTTP Redirect

Perform this task to configure policy maps for http redirect.
Before You Begin
The configuration steps mentioned in
Configuring Class Maps for HTTP Redirection, on page 263
configuration of the policy-map for HTTPR.
OL-28375-03
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
Purpose
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Identifying HTTP Destinations for Redirection, on page 259
have to be completed before performing the
Configuring Policy Map for HTTP Redirect
4.3.x
and
265