Command Or Action; Purpose; Example; Step 1 - Cisco ASR 9000 Series Configuration Manual

DHCPv6 Features
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. Use any of these encapsulations to configure encapsulated ambiguous VLANs:
4. ipv4 | ipv6address source-ip-address destination-ip-address
5. service-policy type control subscriber policy_name
6. ipsubscriber { ipv4|ipv6 } l2-connected

7. initiator dhcp

8. Use the commit or end command.
DETAILED STEPS

Command or Action

Step 1

configure

Example:

RP/0/RSP0/CPU0:router# configure
Step 2
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
Bundle-Ether100.12
Step 3 Use any of these encapsulations to configure encapsulated
ambiguous VLANs:
• encapsulation ambiguous { dot1q | dot1ad } {any |
vlan-range }
• encapsulation ambiguous dot1q vlan-id second-dot1q
{ any | vlan-range }
• encapsulation ambiguous dot1q any second-dot1q {
any | vlan-id }
• encapsulation ambiguous dot1ad vlan-id dot1q { any |
vlan-range }
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.3.x
162
• encapsulation ambiguous { dot1q | dot1ad } {any | vlan-range }
• encapsulation ambiguous dot1q vlan-id second-dot1q { any | vlan-range }
• encapsulation ambiguous dot1q any second-dot1q { any | vlan-id }
• encapsulation ambiguous dot1ad vlan-id dot1q { any | vlan-range }
Establishing Subscriber Sessions

Purpose

Enters global configuration mode.
Configures the interface and enters the interface
configuration mode.
Configures IEEE 802.1Q VLAN configuration.
The vlan-range can be given in comma-separated, or
hyphen-separated format, or a combination of both, as
shown in the examples.
Although encapsulation ambiguous dot1ad
Note
is supported, it is not commonly used in BNG
deployments.
OL-28375-03