Configuring Remote Management; Configuring Remote Access Protocols And Ports - Cisco Small Business RV315W Administration Manual

System Management

Configuring Remote Management

STEP 3
Configuring Remote Management
STEP 1
STEP 2
Cisco RV315W Broadband Wireless VPN Router Administration Guide
• Encryption Method: (Optional) Select either None or CBC-DES as the
encryption method.
• SNMP Read-Only Community: Enter the read-only community used to
access the SNMP entity.
• SNMP Read-Write Community: Enter the read-write community used to
access the SNMP entity.
• Trap Community: Enter the community that the remote trap receiver host
receives the traps or notifications sent by the SNMP entity.
• SNMP Trusted Host: Enter the IP address or domain name of the host
trusted by the SNMP entity. The trusted host can access the SNMP entity.
Entering 0.0.0.0 in this field allows any host to access the SNMP entity.
• Trap Receiver Host: Enter the IP address or domain name of the remote host
that is used to receive the SNMP traps.
Click Save to save your settings.
You can access web-based Configuration Utility from the LAN side by using the
RV315W LAN IP address and HTTP, or from the WAN side by using the RV315W
WAN IP address and HTTPS (HTTP over SSL) or HTTP. You can also remotely
access the RV315W through SSH for system troubleshooting.

Configuring Remote Access Protocols and Ports

The RV315W allows remote management securely by using HTTPS or HTTP, for
example, https://xxx.xxx.xxx.xxx:443.
To configure the protocol and port number for remote management:
Click System Management > Remote Management > Remote Access
Protocols and Ports. The Remote Access Protocols and Ports page opens.
Enter the following information:
• HTTP: Click Enable to enable remote management by using HTTP, or click
disable to disable it.
9
99