Auto Called Id - Nortel Norstar System Administration Manual

180 Call services

Auto called ID

Compact Plus System Administration Guide
This setting applies to Norstar/BST extensions only. ISDN
terminals can receive calling line identification automatically if
supported by the terminal.
The Auto called ID (identification) momentarily shows the
number of the called party on the display of a Norstar/BST
extension. The default is No, the Auto called ID is not displayed.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ≠. The display shows Show extn#:.
5. Enter the extension number of the telephone you wish to
programme. The displays shows nnn:nnn.
6. Press ≠. The display shows Line access.
7. Press ' until the display shows Call services.
8. Press ≠. The display shows Auto call info.
9. Press ' until the display shows Auto called ID:.
10. Press CHANGE to choose N (No) or Y (Yes).
11. Press ® to exit or ' to continue programming.
P0607114 Issue 01