Setting The Administrator Password; Setting The Basic Password - Nortel Norstar System Administration Manual

Setting the Administrator password

Erasing the Administrator password

Setting the Basic password

P0607114 Issue 01
The Administrator password is one to six digits long and allows
you to access programming. The default password is
¤‹fl›fl, which spells ADMIN on the keypad.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' four times. The display shows Passwords.
5. Press ≠. The display shows COS pswds.
6. Press '. The display shows Progrming pswds ˆ.
7. Press ≠ until the display shows Sys admin:.
8. Press CHANGE and enter the new password.
9. Press OK to accept the new password.
If you leave the Administrator password blank (by entering no
digits in step 8), the password is erased. If you erase the
password, anyone can enter Administrator programming without
a password.
The Basic password is one to six digits long and allows you to
access some programming settings using feature codes. You
cannot enter regular programming with this password. The
default is ¤¤‡›¤, which spells BASIC on the keypad.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' four times. The display shows Passwords.
5. Press ≠. The display shows COS pswds.
6. Press ' until the display shows Progrming pswds.
7. Press ≠. The display shows SysAdmin+:.
Compact Plus System Administration Guide
Passwords 173