Changing The Time And Date; Changing The Time - Nortel Norstar System Administration Manual

72 Changing the time and date

Changing the time and date

Changing the time

Compact Plus System Administration Guide
The current time and date appear on the display of idle
Norstar/Business Series Terminal (BST) telephones. Telephones
connected to an Analogue Terminal Adapter cannot display the
time and date. Whenever the mains is interrupted, the time is lost
on the clock and needs
reprogramming.
Note: You need only change the time and date at one
Norstar/BST telephone. The clock is reset for the entire
system.
The clock also controls the schedules used for services such as
ringing and routing.
After a power failure, the clock is behind by the length of time
power was lost. For example, if the power is out for two minutes,
the clock is two minutes behind.
See 'Chart 4: Time and Date' on page 317 in Appendix A for a
programming overview.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password :.
3. Press ¤‹fl›fl (ADMIN). The display shows
Terminals&Extns.
4. Press 'until the display shows Time&Date.
5. Press ≠. The display shows Hour:.
6. Press CHANGE (or NEXT if you do not need to change the hour).
7. Enter the hour (00 to 23). If the number is less than 13, the
display shows AM. Press CHANGE to select PM.
8. Press '. The display shows Minutes:.
9. Press CHANGE.
10. Enter the minutes (00 to 59).
11. Press ® to exit or ' to continue programming.
P0607114 Issue 01