Selecting A Line; Setting The System To Display A Name Instead Of A Number - Nortel Norstar System Administration Manual

Selecting a line

Setting the system to display a name instead of a
number
P0607114 Issue 01
After assigning a telephone number to the speed dial code, you
must select an outgoing facility for the number to use. Choose a
Prime line, an exchange line, a line pool, or the routing table.
When you programme a line pool as part of a speed dial number,
use the programme key labelled Intercom and the line pool access
code, or a programmed line pool key.
If you assign a specific line to a System speed dial number, only
extensions with an appearance of that line can use the speed dial
number.
1. Begin with the display showing the speed dial code you just
changed in the previous procedure.
2. Press '. The display shows Use prime line.
3. Press CHANGE to choose Use prime line, Use routing tabl, Use
line, or Pool code. Stop pressing CHANGE when you see the
line you want to use for the speed dial.
4. Press ® to exit or ' to continue programming.
You can choose to have the display show either the extension
number or a name for a speed dial code. For example, you could
programme a speed dial for a frequently used courier and have the
display show Courier instead of the courier's telephone number.
System speed dial names can be 16 characters long. The default
displays the number.
Alpha tagging: If you specify a name for a system speed dial,
and your system is set up for CLI display, an incoming call on a
number-only CLI line that matches the system speed dial number
will display whatever name you entered into the system speed
dial name field. This is referred to as alpha tagging. You can
determine how many digits of the incoming call and the number
entered into the system speed dial must match before the system
determines that the numbers are the same. Refer to "CLID
Match" on page 144.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ' until the display shows Sys speed dial.
Setting System speed dial 63
Compact Plus System Administration Guide