Assigning Telephones To The Direct-Dial Extension - Nortel Norstar System Administration Manual

106 Programming capabilities

Assigning telephones to the Direct-Dial extension

Compact Plus System Administration Guide
This setting allows you to programme which Direct-Dial
extensions the telephone can call. Direct-Dial extension numbers
and the digits you use to reach Direct-Dial telephones are
programmed in System programming. See 'Assigning a Direct-
Dial extension' on page 75.
Direct-Dial extensions are usually a receptionist for your office or
for a particular department.
You can change which Direct-Dial telephone an extension is
assigned to including none at all. Any number of telephones can
be assigned to call the Direct-Dial telephone.
See 'Chart 11: Extension capabilities 3' on page 324 in Appendix
A for a programming overview.
See 'Accessing a Direct-Dial extension' on page 266 for
information on using this feature.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ¤‹fl›fl (ADMIN). The display shows
Terminals&Extns.
4. Press ≠ The display shows Show extn#:.
.
5. Enter the extension number of the telephone you wish to
programme. The displays shows nnn:nnn.
6. Press ≠ twice. The display shows Fwd no answer.
7. Press ' until the display shows D-Dial.
8. Press CHANGE to select Extn1 or None.
9. Press ® to exit or ' to continue programming.
P0607114 Issue 01