Programming User Preferences; Changing The Key Programming For An Extension - Nortel Norstar System Administration Manual

112 Programming User preferences

Programming User preferences

Changing the key programming for an extension

Compact Plus System Administration Guide
The User preferences section of programming allows you to
programme memory keys, speed dial codes, and other settings for
any Norstar/BST telephone on the system.
For example, an employee may want to have the Do Not Disturb
feature programmed to a memory key or create a speed dial code.
Instead of programming from that employee's telephone, you can
enter User preferences on the nearest telephone to make the
change.
See 'Chart 13: User preferences' on page 326, for a programming
overview.
You can copy User preferences settings from one extension to
another whenever COPY appears on the display. The only
programming that does not get copied is key programming
between different models of telephone.
If there is one or more key on a particular model of telephone that
you would like to change, you can customise one key at a time.
1. Place the programming overlay over the appropriate keys on
your programming telephone.
2. Press ≤••¤flfl‹›› (CONFIG). The
display shows Password:.
3. Press ‡¤‡fi°‡ (SAPLUS). The display shows
Terminals&Extns.
4. Press ≠ The display shows Show extn#:.
.
5. Enter the extension number of the telephone you wish to
programme. The display shows nnn:nnn.
6. Press ≠. The display shows Line access.
7. Press ' until the display shows User prefernces.
8. Press ≠. The display shows Model: followed by a
five-digit code.
9. Press '. The display shows Key prgrming.
10. Press ≠. The display shows how many keys are on
that model of telephone.
11. Press FIND or press ' to see a list of key
programming.
12. Press TEL#, FEATR, or CLR to change the programming for any
key.
13. Press ® to exit or ' to continue programming.
P0607114 Issue 01