Nortel Norstar System Administration Manual page 50

50 Programming Hospitality Services
Changing or cancelling an earlier selected Alarm time
Cancelling the alarm
Turning off the Alarm
Compact Plus System Administration Guide
To programme the Alarm time feature on M7000/T7000
telephones or analogue telephone:
1. Press ≤°‡fi on M7000/T7000 telephones or
press ¿•°‡fi on an analogue telephone.
A tone sounds.
2. Enter a four-digit alarm time.
— If the 24-hour clock format is used (hour: 00 to 23 and
minutes: 00 to 59), a tone sounds.
— If the 12-hour format is used, press • to select am or £
to select pm. A tone sounds.
At the selected times, telephones in the room ring to wake-up or
remind the occupant of the next event or meeting. If Music on
hold is programmed for the system the occupant will hear music
when they answer a wake-up call.
To set a new time for an Alarm time, re-enter a new Alarm time.
The new time overwrites any earlier set time. Cancelling the
Alarm time for any telephone cancels the Alarm time for all the
telephones in the same room.
• To cancel the Alarm time on a Business Series Terminals or
Norstar/BST telephones, press ≤£°‡fi. The display
reads Alarm off.
• To cancel the Alarm time on an analogue telephone, press
¿£°‡fi.
When a telephone rings at the selected time, the occupant can
release the Alarm ring as follows:
• Press any key except the ≥ key.
• On an analogue telephone lift and replace the handset back
into position.
Note: If the user presses the ≥ key when the telephone rings,
the alarm is temporarily deactivated (snooze). After a
number of minutes, the telephone will alert again. If the
user is on a call when the alarm sounds, they can press any
key except ® to cancel the alarm and maintain their
active call.
P0607114 Issue 01