Minimum Reference Mass; Setting A Reference Unit By Entering Known Piece Mass - RADWAG WPY User Manual

26.2.2. Minimum reference mass

Users before beginning the procedure of single piese mass evaluation can
declare "minimum reference mass" i.e. minimum total weight of all pieces
put on the scale pan expressed in reading divisions.
Procedure:
• Enter parameter group <
24 of this manual,
• Choose „
and then set an appropriate value.
Accessible settings: 1 d, 2 d, 5 d, 10 d.
Notice:
While the procedure of evaluation the mass of single piece the the mass
of all pieces put on the pan is lower than the value declared in parameter
„ Minimum reference mass", the following warning message will
be displayed: < Too low sample mass>.

26.3. Setting a reference unit by entering known piece mass

Procedure:
• Enter mode <
of this manual,
• Press
<Reference Unit> with the screen keyboard,
• Enter a value and confirm it by pressing
Counting Pieces> with automatic setting the reference unit.
<
Notice:
1. In case of entering a reference unit higher then the maximum weighing
range of the main scale the program will display a message box:
<Value too high>,
2. In case of entering the single piece mass lower than 0.1 d, the
program will display a message box: <Value to small>.
Counting pieces /
Parts counting> according to ch. 26.1
(enter piece mass), then an editing field is displayed
It concerns the <
Working modes> according to ch.
Minimum reference mass"
95
Counting pieces> working mode
, which causes starting