• Place determined mass on pan of platform 1 and then select
• After the procedure of adjustment factor determination following
command appears:
• Accept the message box by pressing
mode.
<
start mass of platform 1.
Notice:
The factory calibration process for platforms 2, 3, 4 is analogical to the one
described above.
22.2. Start mass adjustment
It is possible to adjust only a start mass, it helps to correct the start zero
when the span does not change.
Procedure:
• Enter submenu <
and select: "
• After entering the parameter the following message box appears:
Setting of start mass> parameter allows to adjust
User Adjustment > according to ch. 22
Setting of start mass",
key and return to weighing
77
,