CLI: Modifying the Interface Access
Interface Access Commands Used in This Section
show console
[no] telnet-server
[no] web-management
console
local terminal mode
Listing the Current Console/Serial Link Configuration. The following
command lists the current interface access parameter settings.
Syntax:
This example shows the switch's default console/serial configuration.
Interface Access
Enable/Disable
Console Control
Options
Figure 7-2. Listing of Show Console Command
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax:
To disable inbound Telnet access:
ProCurve(config)# no telnet-server
To re-enable inbound Telnet access:
ProCurve(config)# telnet-server
Interface Access: Console/Serial Link, Web, and Telnet
below
below
page 7-6
page 7-6
page 7-8
show console
[no] telnet-server
Interface Access and System Information
Event Log Event
Types To List
7-5