Cli: Modifying The Interface Access - HP ProCurve 2810 Series Management And Configuration Manual

N o t e
Interface Access
Enable/Disable
Console Control
Options
Figure 7-2. Listing of Show Console Command

CLI: Modifying the Interface Access

Interface Access Commands Used in This Section
show console
[no] telnet-server
[no] web-management
console
local terminal mode
Listing the Current Console/Serial Link Configuration. The following
command lists the current interface access parameter settings.
Syntax: show console
This example shows the switch's default console/serial configuration.
The serial connection for the 2810 switch is an RJ45 port located on the left
front panel of the switch.
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax: [no] telnet-server
To disable inbound Telnet access:
ProCurve(config)# no telnet-server
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Telnet
below
below
page 7-6
page 7-6
page 7-8
Event Log Event
Types To List
7-5