Cli: Configuring Ip Address, Gateway, And Time-To-Live (Ttl) - HP ProCurve 2610-PWR Management And Configuration Manual

CLI: Configuring IP Address, Gateway, and Time-To-
Live (TTL)
IP Commands Used in This Section
show ip
vlan <vlan-id> ip
address
ip default-gateway
ip ttl
Viewing the Current IP Configuration. The following command displays
the IP addressing for each VLAN configured in the switch. If only the
DEFAULT_VLAN exists, then its IP configuration applies to all ports in the
switch. Where multiple VLANs are configured, the IP addressing is listed per
VLAN. The display includes switch-wide packet time-to-live, and (if config­
ured) the switch's default gateway and Timep configuration.
Syntax: show ip
For example, in the factory-default configuration (no IP addressing assigned),
the switch's IP addressing appears as:
Figure 8-2. Example of the Switch's Default IP Addressing
With multiple VLANs and some other features configured, show ip provides
additional information:
page 8-7
page 8-8
page 8-11
page 8-11
Configuring IP Addressing
IP Configuration
8-7